Product Description
To make sure your brushes stay healthy and clean, check them for wear every few months or when they start looking dull. Then replace both motor-brushes even if one looks more worn than the other! FYI: When they you get a brand new pair of motor brushes they are almost 3/4" long. You should replace them when they get worn down to 1/4"
The motor brushes fit these discontinued motors:
- Series R and RB (115 Volt and 230 Volt).
- Series EE, GG, and MMG motors (115 Volt and 230 Volt).
- Series CC, DD and MM motors (230 Volt).
All Foredom electric motors have two brushes on each side of the case, opposite to where you would put your shaft end. The copper or brass tubes that house these appliances are encased in plastic with shallow screw caps for retention and access purposes when needed Most 2-pole types use one set per motor so there's no need worry about which kind yours is!
The brush is a key component of any electric motor. It provides the lowest possible resistance and friction, which helps to extend its life by helping prevent wear from occurring sooner than it would otherwise occur with other types or materials used for Brushes not having these characteristics.
The flexible copper pigtail endures high pressure when inserted into openings on either side of an electrical device's rotating circuits--matched perfectly in terms if curve communication between commutator blade pathway curvatures so they can match each other up properly while also providing insulation against voltage surges due directly stemming off electricity flow through this part alone!